Huawei eSpace 6805 Administrator's Manual page 117

Huawei IP Phone eSpace
6805&6810&6830&6850&6870
Administrator Guide
Figure 5-63 Value of Filter on the toolbar
SOAP Protocol Analysis
This topic describes how to use the Wireshark to analyze SOAP packets.
Background
To capture a Simple Object Access Protocol (SOAP) packet, pay attention to the following
information:



Figure 5-64 Filter criteria
Issue 01 (2012-06-20)
− From
Source address of the request.
− To
Logical receiver of the request.
− User-Agent
Information about the User Agent Client (UAC) that initiates the request.
If the value of User-Agent is Conf-serv/3GPP, the request is initiated by a personal
computer (PC).
Capture the packet on the AS.
− Install the Wireshark of the Linux operating system on the AS.
− After capturing a SOAP packet using a command on the AS, use the Wireshark to
analyze the captured SOAP packet on the Windows host.
tcpdump -i eth0(actual network adapter name) -w Packet name -s 1200
After choosing Capture > Options to set parameters, do not enter any information in the
Capture Filter text box.
Enter http in the Filter text box when capturing SOAP packets, as shown in
After capturing the SOAP packet is completed, the Hypertext Transfer Protocol (HTTP)
signaling that passes through the network adapter with the IP address of the host is
displayed, as shown in Figure
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-65.
5 Appendix
Figure 5-64.
112