Huawei eSpace 6805 Administrator's Manual page 14

Huawei IP Phone eSpace
6805&6810&6830&6850&6870
Administrator Guide
Table 2-2 Parameters on the ADVANCED SETTINGS page
Field
Admin
Password
Layer 3 QoS
Layer 2 QoS
Local RTP
port
Use Random
Port
Keep-alive
interval
Use NAT IP
STUN Server
Firmware
Upgrade and
Provisioning
XML Config
File Password
HTTP/HTTPS
User Name
HTTP/HTTPS
Password
Issue 01 (2012-06-20)
Description
Administrator password. Only the administrator can configure the
ADVANCED SETTINGS tab page. The Password field is blank for
security reasons after updating and saving. The password contains a
maximum of 30 characters.
Layer 3 QoS parameter, which is used for the IP precedence, Diff-Serv
value, or EXP priority of MPLS packets. The default value is 12.
Layer 2 QoS parameter, which is used to set the 802.1q VLAN flag value
and 802.1p priority value. The default value is 0.
This parameter defines the local RTP port pair used to listen and transmit
messages. It is the base RTP port for channel 0.
When an application initiates an RTP session, two ports are used. One is
used for RTP, and the other is used for RTCP.
When the parameter is set, channel 0 takes port_value as the RTP port
value, and port_value+1 as the RTCP port value; channel 1 takes
port_value+2 as the RTP port value and port_value+3 as the RTCP port
value. The default value is 5004.
When this parameter is set to Yes, the phone forces the random
generation of both the local SIP and RTP ports. This is necessary when
multiple phones are behind the same NAT. The default value is No.
This parameter specifies how often the phone sends a blank UDP packet
to the SIP server in order to keep hole on the NAT router open. The
default value is 20 and the minimum value is 10.
NAT IP address used in the SIP/SDP message. By default, this parameter
is left blank.
IP address or domain name of the STUN server.
This parameter is used to set the time for upgrading the firmware. The
default mode is Always Check for New Firmware.
 Always Check for New Firmware: The phone always checks
whether there is a new software version of the server.
 Check New Firmware only when F/W pre/suffix changes: The
phone checks the prefix and suffix of the upgrade file name. This
mode is specifically for the ITSP.
 Always Skip the Firmware Check: The phone skips the version
check and retains the current version.
If you have used the XML Provision mode to update the configuration
file and have used encryption tools such as the Openssl to encrypt the
file, this parameter specifies a password for the phone to decrypt the
downloaded XML file.
If the HTTP or HTTPS firmware or configuration server adopts the user
authentication mode, set this parameter to the authorized user name.
If the HTTP or HTTPS firmware or configuration server adopts the user
authentication mode, set this parameter to the authorized password.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Configuration and Loading Files
9