Panasonic DMR-E50 Operating Instructions Manual page 45

Numbered
buttons
SETUP
Panasonic DVD players and recorders use the same remote control
system so they may respond unintentionally to a command from this
remote control. Change the code on this unit and its remote control
(the two must match) if you place equipment close together.
l
Use "I", the factory set code, under normal circumstances.
1
While stopped
Press [SETUP] to show the menus.
2
Press [A, V] to select 'Set Up" and
press [Fj.
3 Press [A, V] to select "Remote Con-
trol Code" and press [ENTER].
4
Press [A, V] to select the code (1, 2,
or 3) and press [ENTER].
The remote control code on the unit has been set.
5 While pressing [ENTER] on the
remote control, press the numbered
button ([I], [2] or [3]) corresponding
to the code you selected in step 4.
The remote control code on the remote control has been set.
6
Press [SETUP]
The following display appears when you use a remote control with a
different code.
The unit's remote control code
If you are trying to use this unit's remote control, change its code to
match the unit's (+ step 5).
Rm
1
RQT6920