ABB COMMANDER 1900 Series Programming Manual page 19

Source
ACFAIL Power Failure
AL_ACK Alarm acknowledge – an unacknowledged process alarm condition anywhere in the unit
SEG–99 Profile segment 99
SEG–0 Profile segment 0
PG-2. 1 0 Profile program 10, Controller 2
PG-1. 0 1 Profile program 1, Controller 1
rUN–x Profile 1 or 2 running
HOLd–x Profile 1 or 2 in Hold mode
OPEN–x Motorized valve 1 or 2 open
CLSE–x Motorized valve 1 or 2 closed
Control output 1 or 2 on/off
OnOFFx
Control output 1 or 2 (time proportioning)
OP–x
Control output cool 1 or 2 (time proportioning)
OP–xc
Control output heat 1 or 2 (time proportioning)
OP–xh
2Nd–x
Second set point
LOC–x
Local set point
MAN–x
Manual control
AUtO–x
Automatic control
tIMEr. 2
Real time event 2
tIMEr. 1
Real time event 1
Logic equation 8
EQN – 8
Logic equation 1
EQN – 1
rAP – 4
Wrap around on total 4
*COUNt. 4
Total 4 external counter drive
rAP – 1
Wrap around on total 1
*COUNt. 1
Total 1 external counter drive
dIG – 6. 8 Digital Input 6.8
dIG – 1. 1 Digital input 1.1
AL – d4
Alarm D
AL – C4
Alarm C
AL – b4
Alarm B
AL – A4
Alarm A
AL – d3
Alarm D
AL – C3
Alarm C
AL – b3
Alarm B
AL – A3
Alarm A
Alarm D
AL – d2
Alarm C
AL – C2
Alarm B
AL – b2
Alarm A
AL – A2
AL – d1 Alarm D
AL – C1 Alarm C
AL – b1 Alarm B
AL – A1 Alarm A
No source required
NONE
*
Only available on 4-relay and 8-digital output modules (types 3 and 5), fitted in module positions 4,5 and 6.
Profile (ramp/soak) control for controller 1 or 2
Motorized valve control for controller 1 or 2
(only available on relay and digital outputss
Set point selected for controller 1 or 2
Control mode selected for controller 1 or 2
Real time events (only available if timer option fitted – see
Programmable logic equations – see Section 4.2,
Wrap around and count (only available if totalizer option fitted)
Digital Input number
Module number
Channel 4 Alarms (if applicable)
Channel 3 Alarms (if applicable)
Channel 2 Alarms (if applicable)
Channel 1 Alarms
Table 3.1 Description of Sources
3 BASIC CONFIGURATION LEVEL...
Description
Only available on relay and
digital outputs
Set Up Logic
Advanced Software Options Manual
17