Set Up Digital Output - ABB COMMANDER 1900 Series Programming Manual

...3.6 Set Up Digital Output

dIGtAL
OUtPtS
SELECt
OUt 1. 1
Module Position
Output No.
NONE
NONE
SOUrCE
EQN–4
NONE
NONE
POLrtY
POStVE
NEGtVE
SELECt
Page Header – Set Up Digital Outputs
To advance to
Set Up Analog Output
Select Digital Output
Select the output to be programmed – the selections in this frame relate to the number of fitted
digital output modules and their relative module positions.
– for a type 5 (eight digital outputs) module fitted in position five the following selections
Example
are also programmable:
OUt 5. 1 (position 5, output 1)
OUt 5. 2
(position 5, output 2)
OUt 5. 3 (position 5, output 3)
OUt 5. 4 (position 5, output 4)
OUt 5. 5 (position 5, output 5)
OUt 5. 6 (position 5, output 6)
OUt 5. 7 (position 5, output 7)
OUt 5. 8 (position 5, output 8)
Note. In the remaining frames press the
Output Source
Select the source required to activate the selected digital output.
For description of sources, refer
Note. To drive an external counter
Polarity
The polarity selection is used to invert the effect of the source state on the output as shown in the
following table:
S o u c r e S a t e t
A c v i t e
N o n a - c v i t e
Select the polarity required
Caution. Check connections before operating – see Section 6,
Return to
Select Digital Output
3 BASIC CONFIGURATION LEVEL...
page press the switch.
switch to view the output selected.
on page 17.
to Table 3.1
COUNt. x
must be selected.
P o a l i r y t
P o i s v i t e
N e g a v i t e
P o i s v i t e
N e g a v i t e
frame.
O u p t t u S a t e t
E n e g r z i e d
D e e - n e g r z i e d
D e e - n e g r z i e d
E n e g r z i e d
.
CONNECTIONS & LINKS
19