...4 CONTROL CONFIGURATION LEVEL
4.4 Set Up Operating Page
Information.
• Customized display of parameters in the Operating Page.
• Power-fail indication – if enabled,
• Auto/Manual switch
SEt UP
OP PGE
SELECt
CtrL 2
CtrL 1
NONE
INCMNt
--
CtrL 1
CtrL 2
PF-INd
YES
NO
Aut. M AN
ENbL-Y
ENBL-N
Mr AdJ
YES
NO
SP-SEL
YES
NO
SP-AdJ
YES
NO
r-AdJ
YES
NO
b-AdJ
YES
NO
SELECt
------
44
LINE FAILEd
is displayed to indicate that a power failure has occurred.
– enable or disable.
Page header – Set Up Operating Page.
To advance to
Set Up Digital Page
Select Controller
Select the controller to be programmed (1 or 2).
Note. In the remaining frames press the
Bargraph Increment
The deviation from set point is shown on the bargraph on the faceplate.
Set the percentage deviation represented by each bar, between 1 and 10% in 1% increments.
Power Fail Indication Enable
Enable or disable power failure indication:
YES
–
enable
NO
–
disable
Auto/Manual Select Enable
Enable or disable the
ENbL-Y
–
enable
ENbL-N
–
disable
Manual Reset Adjustment Enable
Enable or disable display and adjustment of the
YES
–
enable
NO
–
disable
Set Point Select Enable
Enable or disable adjustment of the
YES
–
enable
NO
–
disable
Set Point Adjust Enable
Enable or disable adjustment of the
YES
–
enable
NO
–
disable
Remote (or Cascade) Set Point Ratio Adjust Enable
Enable or disable display and adjustment of the
.
Operating Page
YES
–
enable
NO
–
disable
Remote (or Cascade) Set Point Bias Adjust Enable
Enable or disable display and adjustment of the
.
Operating Page
YES
–
enable
NO
–
disable
Return to
Select Controller
press the
switch.
switch to view the controller selected.
switch on the faceplate:
Manual Reset
Set Point Type Selection
Control Set Point
Remote (or Cascade) Set Point Ratio
Remote (or Cascade) Set Point Bias
frame.
frame in the
Operating Page
frame in the
Operating Page
value in the
Operating Page
:
:
:
in the
in the