Table of Contents
Advertisement
5.1.10. Self cleaning cycle ( only on pyrolitic ovens)
STATUS
DISPLAY SHOWS
D1 shows Clock
ON STATUS
D2 is OFF
After pressing
SELF CLEANING
→ D1 shows default 02:00
CYCLE
D2 shows "Pyro"
Setting
Icon
DURATION
D1 shows 02:00 flashing
TIMER
D2 shows "Pyro"
Setting
D1 show the countdown
D2 show "Pyro"
SELF CLEANING
Door lock activates and, when acti-
CYCLE
Active
vated, the icon
COUNTDOWN
D1 shows "StOP" flashing
Expires
D2 shows "Pyro"
COOKING CYCLE
Emitted 10 sounds only once
Stopped
While the door lock is activated, is not possible to activate any other cooking function:
so
5.1.11. Defrosting and proving
STATUS
DISPLAY SHOWS
D1 shows Clock
ON STATUS
D2 is OFF
D1 shows the clock
D2 shows default temperature
DEFROSTING
OR PROVING
Setting
Icon
D1 show the clock
COOKING
D2 show the temperature
CYCLE
active
Same condition of manual cooking (see §6)
KEYS USE
→
flashes
gets ON
key are not enabled, oven lamp is OFF. Wait the door unlocking.
KEYS USE
and
are ON
Set the UI to STAND-BY status
Select a cooking function
Set a minute minder (see §7)
Set the UI to STAND-BY status
Modify the set function (see §6)
Change the countdown in the range 02:00 - 03:00.
In case of PYRO ECO is not possible to change the countdown,
but the key must be pressed to enable the self-cleaning cycle to start.
3sec after the edit of last item, the countdown and the cycle starts.
Keep pressed for 3 sec to set the UI to STAND-BY status
Increase/decrease countdown, with higher speed if keep pressed.
Max possible countdown 13h.
3sec after the edit of last item, the countdown restarts.
Keep pressed for 3 sec to set the UI to STAND-BY status
Modify the countdown (as above described)
Keep pressed for 3 sec to set the UI to STAND-BY status
Set the UI to STAND-BY status
Select a cooking function
Set a minute minder (see §6)
Set the UI to STAND-BY status
Flashes to point at the "Function setting"
Modify the default temperature, steps of 5°C degrees
• Setting the temperature of 40°C proving is activated
Internal fan OFF, temperature managed by PT1000 sensor
• Setting the temperature of 30°C defrosting is activated
Internal fan ON, temperature managed by PT1000 sensor
Set a minute minder timer
Set a duration timer
Select the function among the ones available
12
Advertisement
Table of Contents
