Table of Contents
Advertisement
5. (1) Tilt the control panel lifting the lower eddge then.
(2) pull it out
6. Remove the screws shown in the picture to remove the
display PCB from the control panel.
? screw A: 8mm socket spanner
? screw B: 6mm socket spanner
7. Make sure that the front panel tabs are correctly
positioned in their slots when reassembling the PCB.
8.8.
COOLING FAN AND FAN DUCT
1. Disconnect the wires running to the right-side oven lamp
in order in order to facilitate the removal of the cooling fan
duct.
2. UPPER DUCT
Remove the 6 screws shown in the picture, disconnect
the wiring to the oven cooling motor and lift the upper
duct.
3. LOWER DUCT
(1) lift the lower duct then
(2) pull it a way from the oven frame
20
Advertisement
Table of Contents
