Table of Contents
Advertisement
PART NAMES AND FUNCTIONS (Continued)
AV SELECTOR SECTION - FRONT
Power indicator lamp
This lamp shows the state of the power supply.
Lit (red):
Lit (green):
Flashing (red or green): Malfunction (Flashes differently depending on the type of malfunction.)
Remote control signal receiver
Receives signals from the remote control.
/l power switch
If this button is pressed with the power indication lamp off, it lights up.
The power can be turned on and the standby mode is selected by using the remote control or the control panel of the display.
If this button is pressed with the power indicator lamp on, it turns off.
*Power is still supplied to parts even if the indicator lamp is off.
Video3, S-video input terminal *
Connect this terminal to the S-video output terminal of your video camera, etc.
Video3, video input terminal *
Connect this terminal to the video output terminal of your video camera, etc.
Audio input terminals (L/R)
These are the audio input terminals for the Video3 and RGB3 terminals.
Input the audio for the video to be seen here.
RGB3 input terminal
Connect this terminal to your PC's mD-sub output terminal.
* On selecting the video input format
(See "SETTING THE INPUT TERMINALS" on P. E-49.)
Warning
If the power indicator lamp flashes red or green, this signifies that the display has developed a problem. When this happens, be sure to remove the
power plug from the receptacle and contact your dealer. Leaving the display power ON can result in fire or electric shock.
E-14
Downloaded From projector-manual.com Fujitsu Manuals
Stand-by
Power ON
Advertisement
Table of Contents
