Installation - Fujitsu LPF-D711W User Manual

INSTALLATION

TAKING OUT THE PROJECTOR FROM THE CARTON
Remove the cushioning material for lens protection.
Be sure to remove the cushioning material. If operating focus, zoom, and shift
of the lens with the cushioning material attached, this may cause damage to
the lens.
INSTALLATION
To prevent increase of temperatures inside the projector, provide a space for draft surrounding the projector. For better heat release, also
provide a space of a minimum distance surrounding the projector, as shown in the figure below.
When installing the projector, be sure to use suspended unit (option) from the ceiling. Call for installation to the local dealer.
See the appropriate instruction manual for more information on the installation hardware you select.
To prevent an accident and ensure safety in the event of an earthquake, fix the display securely into position as described below.
To ensure proper heat radiation, provide at least as much space around the display as shown below.
* Be sure to install the projector at a place that can keep the ambient temperature ranging from 5 to 35
* Run the power cords and connection cables along the wall and at the corners of the floor.
* Connect the projector and the AV selector with optical DVI-D cable with care not to bend the cable sharply. Otherwise the cable may
cause damage.
* To prevent the accident and ensure safety against an earthquake, make measures for prevention of falling.
Projector Section
20
Left
AV Selector section
10
Left
Downloaded From projector-manual.com Fujitsu Manuals
Front
(cm)
Upper
20
20
Right
Lower
Front
(cm)
Upper
10
10
Right
Lower
Cushioning material
.
Side
(cm)
Upper
20
20
Rear
Lower
Side
(cm)
Upper
10
10
Rear
Lower
E-9