Connecting The Ac Adapter For Use With The Pan-Tilt Head - Panasonic AW- PH350 Operating Instructions Manual

Connections

$Connecting the AC adapter for use with the pan-tilt head

Connect the pan-tilt head with the AW-PS300 AC adapter designed for use with the pan-
tilt head.
1394
G/L I N
;DC 12V IN terminal board
Connect this to the DC 15V OUT
connector on the AC adapter (AW-
PS300). (The voltage output from the
AC adapter is set to 15V: this takes into
consideration the voltage drops due to
the possible extension of the DC cable
between the pan-tilt head and AC
adapter.)
Make sure that the positive + and
negative - ends of the wires are
connected to the same signs on the
connector.
Use a cable with a nominal cross section
2
of 1.25 mm or more which complies
with the Electrical Appliance and
Material Control Law for the connection.
<LAMP CONTROL terminal board
Connect this only when the power of a
halogen lamp is to be supplied from the
LAMP AC OUT connector on the AC
adapter (AW-PS300).
This connector is connected to LAMP
CONTROL on the AC adapter for the
pan-tilt head.
The symbols C and S on the wires must
match the same symbols on the
connector.
ND/EXT
IN
SDI
I/F LENSE
I/F CAMERA
DC12V LAMP
CONTROL IN
IN CONTROL
IP/RP
+ - C S O P
Pb OUT Pr /SDI Y/VIDEO
OUT OUT
<
;
Approx. 1 cm
=
It is recommended that the tip be soldered.
Use a cable with a nominal cross section
of 0.3 mm 2
the Electrical Appliance and Material
Control Law for the connection.
=OP terminal board
Connect this only when the OP SW
CONTROL OUT connector on the AC
adapter (AW-PS300) is to be used.
Connect it
CONTROL IN connector on the AC
adapter (AW-PS300).
Use a cable with a nominal cross section
of 0.3 mm 2
the Electrical Appliance and Material
Control Law for the connection.
21
AC adapter for use with the
pan-tilt head:
AW-PS300
or more that complies with
to the OPTION
or more that complies with
SW