Motorola AP 7161 Installation Manual page 16

16
When mounting antennas to connectors marked R2-A, R2-B and R2-C, these antenna ports relate to the software
settings of radio 2. Care must be taken to provide the correct antenna for the operating band of each port.
AP 7161 three radio models (AP-7161-66S40-US and AP-7161-66S40-WR) are configured with eight N type
connectors to support two active WLAN data radios and a dedicated sensor radio as the third.
As with the two radio models, R1 ports relate to the software configured radio 1 settings. When mounting
antennas to connectors marked R2-A, R2-B and R2-C, the antenna ports relate to the software configured radio 2
settings. Care must be taken to provide the correct antenna for the operating band of each port.
Ports R3-A and R3-B are reserved for the sensor radio. An appropriate multi band antenna should be mounted on
the unit for sensor operation.
NOTE
WARNING!
The sensor radio does not function as a WLAN data radio.
Antenna ports where no antenna is mounted must be properly terminated using an
approved IP67 terminator.
AP 7161 Access Point Installation Guide