AP 7161 Access Point Installation Guide
To use only the extension arm:
Using four #10/32 lag bolts, attach the extension arm at the desired mounting location.
1.
Using a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, attach the mounting extension
2.
arm to the access point with four M6 hex flange screws. Tighten the hex flange screws to 60 inch pounds
(lbf-in).
To use the extension arm with the mounting hardware kit:
With the open slot connections facing down, attach the angle adjust bracket section at the desired mounting
1.
location using four #10/32 lag bolts.
Complete the steps for assembling and positioning the angle adapter bracket and access point bracket sections
2.
outlined above.
With the access point positioned so that the gore vent is facing down, attach the extension arm to the access
3.
point bracket section of the assembled mounting bracket already in position using four M6 hex flange screws.
Tighten the hex flange screws to 60 inch pounds (lbf-in).
Using a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, attach the extension arm to
4.
the access point with four M6 hex flange screws. Tighten the hex flange screws to 60 inch pounds (lbf-in).
31