Motorola AP 7161 Installation Manual page 33

AP 7161 Access Point Installation Guide
Use following procedure for installing an AP 7161 access point VMM:
Position the AP 7161 VMM upside down with the eight screw holes facing upwards.
1.
Put the flat plate on top of the VMM. Align the key hole and four screw holes on the flat plate with the philips
2.
screw head and four screw holes on the VMM.
Put the chassis mount on the flat plate with the key hole and four screw holes aligned.
3.
NOTE
Put the stiffener plate on the chassis mount with the key hole and four screw holes aligned.
4.
Insert four screws with washers through the holes of the three plates and into the screw holes on the bottom of
5.
the VMM.
Using a 5mm allen wrench or box wrench, tighten the screws to 150 inch pounds (lbf-in) .
6.
Set the VMM and top bracket sub-assembly aside.
7.
Locate the mount point position for the VMM in the vehicle. Ensure there is sufficient clearance for cables and
8.
antennas. The surface should be metal (1.0 mm minimum thickness), hard plastic or plywood, and capable of
supporting the weight of the VMM and bracket assembly.
Attach the vehicle mount securely to the mount point with metal screws or bolts (not provided).
9.
Securely attach the AP 7161 top bracket sub-assembly to the vehicle mount with the four pre-installed thumb
10.
screws. Tighten the screws to 90 inch pounds (lbf-in) using a philips screwdriver or pliers.
Attach three RP-SMAF adaptors (part number 25-90263-02R) to the N connectors on the active mobile radio on
11.
the VMM. Radio 1 ports are labeled R1-A, R1-B, and R1-C. Radio 2 ports are labeled R2-A, R2-B, and R2-C.
Attach the antennas to the adaptors for each radio to be enabled.
12.
Connect the CAT5E cable providing power to the RJ45 port labeled GE1/POE.
13.
WARNING!
Apply power to the source and observe that the LEDs are illuminated.
14.
The screw heads on the chassis mount should be facing down.
Connecting power to any other port could damage the unit.
33