Table of Contents
Advertisement
After every operation
"Fill water tank"
message
12
If your tap water contains a high percentage of
chlorides (> 40 mg/l), use still mineral water low in
chlorides. You can obtain information on your tap
water from your water supply company.
Before using for the first time, moisten the tank cover
seal with a little water.
Caution.
Do not fill the water tank with distilled water or any
other liquids. You may damage the appliance.
Fill the water tank before each use
1. Fill the water tank with cold water up to the
"max." mark.
2. Close the tank cover until you feel it engage.
3. Slide in the water tank until it engages.
Empty the water tank after each use.
1. Pull the water tank out of the appliance slowly,
keeping it horizontal, so that no remaining water
can drip out of the valve.
2. Empty out the water.
3. Thoroughly dry the water tank in the appliance and
the seal in the tank cover.
If the water tank is empty, a signal sounds. "Fill water
tank" appears in the display. Operation is stopped.
1. Open the appliance door carefully. Steam will
escape.
2. Take out the water tank, fill to the mark and
reinsert.
3. Press the Start button.
Advertisement
Table of Contents
