Bios Setup Program; Entering Bios Setup Program; Clearing Forgotten Passwords - Dell Embedded Box PC 5000 Service Manual

BIOS setup program

Entering BIOS setup program

Before turning on the Embedded Box PC, connect the keyboard, mouse, and
monitor to the Embedded Box PC, or connect the Embedded Box PC through
the KVM session or use Dell Wyse Cloud Client Manager (CCM) or Dell
Command | Monitor (DCM) to update the BIOS configuration.
1 Turn on (or restart) the Embedded Box PC.
2 During POST, when the DELL logo is displayed, watch for the F2 prompt
to appear, and then press F2 immediately.
NOTE: The F2 prompt indicates that the keyboard is initialized. This
prompt can appear very quickly, so you must watch for it, and then
press F2. If you press F2 before the F2 prompt, this keystroke is lost.
If you wait too long and the operating system logo appears,
continue to wait until you see the desktop. Then, restart the
Embedded Box PC and try again.

Clearing forgotten passwords

NOTE: The Embedded Box PC must be disconnected from the electrical
outlet to clear the password setting.
1 Follow step 1 to step 6 in
2 Locate the password reset jumper (PWD) on the system board. See
"System-board
3 Move the jumper plug from pins 1 and 2 to 2 and 3.
4 Follow step 2 to step 9 in
5 Turn on the Embedded Box PC, and wait until the message stating that
the password has been cleared appears.
6 Shut down the Embedded Box PC.
"Removing the back
components".
"Replacing the back
cover".
cover".
111