Removing the CANbus cable
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
1
Follow step 1 to step 6 in
2
Remove the
Procedure
1
Disconnect the CANbus cable from the connector on the CANbus card.
2
Remove the CANbus cable from the routing guides on the chassis.
3
Slide the cable out from under the heat sink pipe.
4
Remove the hexagonal screws that secure the CANbus port to the top
cover.
74
Before working inside your Embedded Box
"Removing the back
PCI/PCIe card
(if installed).
PC. For more safety best practices,
www.dell.com/
cover".
PC.
After