Removing the CANbus card
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
1
Follow step 1 to step 6 in
2
Remove the
Procedure
NOTE: Embedded Box PC is shipped with a combination of WWAN,
WLAN, and CANbus card depending on the configuration ordered.
1
Disconnect the CANbus cable from the connector on the CANbus card.
2
Remove the screws that secure the CANbus card to the system board.
Before working inside your Embedded Box
"Removing the back
PCI/PCIe card
(if installed).
PC. For more safety best practices,
www.dell.com/
cover".
PC.
After
77