Edit (Ff) - Panasonic DBS 576 Technical Manual

Built-In ACD Supervisor Guide
Com-
No Parameter1
mand
6 RET Program Line
Number Set-
ting 1 to 20
(max. 20
lines)
(must be set)
7 RAD Port #
Operation
The following describes operation in each of the processes.
EDIT (FF1)
This command resets the current setting of displayed program lines. Edit is
repeated from the specified program line through to the currently registered
final program line (excluding the END/DISC line).
The following screen display shows an example of selection and setting of the
SEARCH command.
SEARCH 1,020,010
03:Select Cmd.
FWD FWDVM
PLAY RET
SEARCH RAD
List
576-3.6-521 (ACD 4.0)
Parameter2 Parameter3
Count Set-
ting 1 to 255
(times)
(must be set)
1. Press soft keys 1 , 2 or 3 or 6, 7 or 8 for the command to be set,
and press the HOLD key.
Example: Press soft key 3 to select SEARCH.
DBS 576 (USA) issued October 2000
Description
Return
• Repeats the program from the line number speci-
fied in parameter 1 up to this line for the count
specified in parameter 2.
Recorded Announcement Device
• The caller hears MOH if the RAD port # is
invalid or incorrect.
• THE DBS 576 Built-in ACD must use different
RAD ports than Easy Run Courier ACD.
• RAD equipment will connect to AEC ports.
• No start or stop control method will be provided
to control the RAD equipment. RAD equipment
must be capable of operating in the continuous
play mode.
• Up to 8 RAD devices can be connected to AEC's
per system.
• This command must be followed by a SEARCH,
FWD or FWDVM command.
• For programming (See Section 400 Programming
Manual on page 1-168.)
Section 521
7