Configuring Tcp/Ip - Dell 5330dn User Manual

Printing a Network Information Page
The Network Information page shows how the network interface card on your printer is configured. The default settings are suitable for most applications. To
print a network information page:
1. Press Menu (
2. Press Scroll (
3. Press Scroll (
Setting Network Protocols
When you first install the printer, all supported network protocols are enabled when you power on the printer. If a network protocol is enabled, the printer may
actively transmit on the network even when the protocol is not in use. This may slightly increase network traffic. To eliminate unnecessary traffic, disable
unused protocols.
1. Press Menu (
2. Press Scroll (
3. Press Scroll (
4. If you selected Ethernet Speed, select a network speed.
If you selected TCP/IP(IPv4) or TCP/IP(IPv6), assign a TCP/IP address. For details, see
If you selected AppleTalk.
a. Press Scroll (
b. Press Scroll (
If you selected Wireless, assign a wireless network environment. For details, see
NOTE: When you set AppleTalk, you must restart your machine to apply new settings.
5. Press Select (

Configuring TCP/IP

Static Addressing: TCP/IP address is assigned manually by the system administrator.
l
Dynamic Addressing BOOTP/DHCP(default): TCP/IP address is assigned automatically by a DHCP or BOOTP server on your network.
l
Setting TCP/IP
To enter the TCP/IP address from your printer's operator panel, take the following steps:
1. Press Menu (
2. Press Scroll (
3. Press Scroll (
If you selected TCP/IP(IPv4):
a. Press Scroll (
b. Press Scroll (
If you selected TCP/IP(IPv6):
a. Press Scroll (
b. Press Scroll (
d. Press Cancel (
Static Addressing
Downloaded from ManualsPrinter.com Manuals
).
to ) to highlight Reports and press Select (
to ) to highlight Network Settings and press Select (
).
to ) to highlight Network I/O Ports and press Select (
to ) until you see the desired protocol and press Select (
to ) to highlight Activate and press Select (
to ) to change the setting to On (enable) or Off (disable).
) to save the selection.
).
to ) to highlight Network I/O Ports and press Select (
to ) to select the network protocol you want to use and press Select (
to ) to highlight IPv4 Activate and press Select (
to ) to change the setting to On (enable) or Off (disable).
to ) to highlight IPv6 Activate and press Select (
to ) to change the setting to On (enable) or Off (disable).
) to return to Standby mode.
Bonjour(Rendezvous), DDNS, WINS, TCP (Port
2000), LPR(Port 515), Raw(Port 9100), IPP Port
Printing/Secure-IPP, SNMPv1/2/3, HTTP/HTTPs,
Telnet, SMTP(E-mail Notification).
).
).
).
).
"Configuring
).
"Configuring TCP/IP".
).
).
).
).
TCP/IP".