Siemens G120P Manual page 21

3.1.1.2
Function Status
Command source Auto
JOG
Manual
Drive state Ready
In operation
Fault display Fault
Alarm display Alarm
Save in the RAM Active
PID autotuning Active
Hibernation Active
Write protection Active
Know-how protection Active
ESM Active
3.1.2
3.1.2.1
Siemens AG
Screen symbols
Symbol Remark
Is displayed if the JOG function is activated
Symbol rotates when the motor is running.
Data is saved in the RAM. If the power supply is
interrupted, all data is lost.
Parameters cannot be changed.
Essential services mode (fire control)
BOP-2
Functions
Button Function
Pressing the button: Confirming the selection

Pressing and holding down the button (> 3 s): Toggling between changing

individual digits and changing the whole value
Pressing the button

– Scrolling up through the menu
– Increasing a parameter value
Pressing the UP and DOWN buttons simultaneously when MANUAL and

JOG mode are activated: Switching the reverse function on and off
Pressing the button

– Scrolling down through the menu
– Reducing a parameter value
Pressing the UP and DOWN buttons simultaneously when MANUAL and

JOG mode are activated: Switching the reverse function on and off
Pressing briefly: Return to the previous display

Pressing and holding down the button (> 3 s): The BOP-2 returns to the

status screen
 In AUTO mode: no function
In MANUAL mode: pressing starts the drive

 In AUTO mode: no function
 In MANUAL mode:
– Pressing briefly: OFF1 - the motor comes to a standstill along the set
down ramp (parameter P1121)
Commissioning
3
Operator panels
21
CM2G5111en
2014-05-16