Data Backup On A Memory Card - Siemens G120P Manual

Commissioning
3

Data backup on a memory card

3.8
36
Siemens AG
Parameter Value Description
p2103.0 r2090.7 Connect the first signal source for acknowledgment to the
communication interface
The "Point numbers" defined in the device for communication via P1 can be found
in the Operating Instructions of the CU230P-2.
Data backup on a memory card
Standard MMC cards or SD cards up to 2GB are supported. Siemens memory
cards provide other functions.
 You require an empty memory card for the following procedure.
1. Switch off the drive power supply.
2. If the Control Unit is connected to a computer via a USB cable, the card is
identified as a bulk storage device and its use is blocked. Remove the USB
cable which has been inserted.
3. Wait until the variable speed drive is in a completely no-voltage condition and
no LED on the Control Unit is lit.
4. Insert the empty memory card into the card slot on the Control Unit.
5. Switch on the operating voltage of the drive.
 After the drive has been switched on, it copies the settings to the memory card.
NOTICE
If the memory card already contains another drive's settings, the drive adopts
those settings.
Data may be lost.
● Use an empty memory card.
CM2G5111en
2014-05-16