Location Of Philips Logo; Location Of Icons; Color For Resin / Paint; Resins - Philips BDL4230E/00 Service Manual

7.3

Location of Philips Logo

Per Philips make-up sheet
Gap between panel and front bezel < 1.2 mm
7.4

Location of Icons

Per Philips make-up sheet

7.5 Color for Resin / Paint

Black 30% gloss front/Silver brush gloss decoration part/Stealth Black in mould back-cover.
7.6

Resins

RoHS requirements.
WEEE requirements.
PC+ABS
China Rohs required. ( sales in China only)

7.7 Paint Used

RoHS requirements.
WEEE requirements.

7.8 Plastic Mold Tooling

Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld
lines, gate marks, ejector marks, etc.).
Painting to cover up cosmetic defects due to molding is strongly discouraged.

7.9 Plastics Flammability

All Plastics to be Flame Retardant UL 94-V0 or Better (if Display weighs less than 18kg; UL94-V0 is
OK).
Base / Pedestal to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover, base) need to be molded from same resin. Base / Pedestal
otherwise specified.

7.10 Texture/Glossing of Housing

The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to UN-D249.
The gloss value of texture area < = 20 gloss units.

7.11 Base Tilt / Swivel Range

Tilt -
Swivel Range -
Base detach -
Tip over -

7.12 Movement of Unit with Base

Base must have non-marring, non-staining feet.
Unit must tilt up and down with no "Stick / Slip".
Base must provide sufficient friction to hold unit in desired position after adjusting tilt.
General Product Specification
N.A. (per commercial spec request)
0°
Should be directly disassembled from main body, so as for easy
install the Display to wall mount.
15° minimum in worst case, base dimension designed so that ID
and tip over requirements can be met.
BDL4230E LCD 95