ABB 800xA User Manual page 39

Section 3 Configuration
Figure 19. Remote Access Client, Special Configuration Tab
To configure the Remote Access Client, execute the following steps:
The Connect account must be configured on the node that executes the Remote
Access Client (AfwRAC.exe).
If the system is redundant, the Connect account must be configured twice. The
password must be configured on the Remote Access Client nodes, and the
Remote Access Service (AfwRAS.exe) node.
For a redundant system, the password must be set four times, that is, twice for the
Remote Access Client and twice for the Remote Access Service.
1.
3BSE037076-510 D
Select Special Configuration tab, and click Set Connect Account. The
connect account dialog is displayed.
Remote Access Client Advanced Configuration
39