Section 3 Configuration
Enabling Point of Control
To use Point of Control in the subscriber system, a valid license key is required and
the Point of Control must be enabled. For more information on Enabling Point of
Control, refer to Enabling Point of Control section in System 800xA Administration
and Security (3BSE037410*).
Execute one of the following methods to enable the Point of Control:
1.
Figure 37. Enabling the Point of Control thru SCC
3BSE037076-510 D
Select Point of Control from Start > ABB Industrial IT 800xA > System >
System Configuration Console > Security.
In the System 800xA Configuration Console dialog, select Yes, enable Point
of Control, and click Apply (see
functionality is disabled.
Enabling Point of Control
Figure
37). By default, the Point of Control
61