Identification Tag; Storage - ABB PQFS Installation, Operation And Maintenance Instructions

3.5

Identification tag

Each PQFS is fitted with nameplates for identification purposes.
The filter nameplate is located at the top right of the master panel door, at the outside.
The nameplate information should always remain readable to ensure proper identification
during the life of the filter. The main filter nameplate includes the filter type, the nominal
voltage range and frequency as well as a serial number and an ABB internal article code.
3.6

Storage

If your PQFS is not installed once unpacked, it should be stored in a clean indoor, dry,
dust free and non-corrosive environment. The storage temperature must be between
-25°C (-13°F) and 70°C (158°F) with a maximum relative humidity of 95%, non-
condensing.
Temperature
Relative humidity
Contamination levels
(IEC 60721-3-3)
Remarks:
(a)
Locations with normal levels of contaminants, experienced in urban areas with industrial
activities scattered over the whole area, or with heavy traffic.
(b)
Locations without special precautions to minimize the presence of sand or dust. Also
applies to locations in close proximity to sand or dust sources.
14 Upon reception ç Manual Power Quality PQFS
Figure 11: Bad using of the lifting ribbon to lift the PQFS
Table 2: Maximum allowed ambient conditions for storage
Storage (in the protected package)
-25 to 70°C (-13 to 158°F)
Max. 85%
Chemical class 3C3
Mechanical class 3S3
(a)
(b)