Table of Contents
Advertisement
After approving the new rating value (
taken into account. In practice, this implies that the output current of the unit will be limited
to the filter nominal current times the entered rating factor. E.g. a rating factor of 50%
implies that the maximum RMS filter current is half the nominal filter current.
Pressing
will result in the original value being restored and the filter rating menu being
quit.
7.7.2.5 Setting up the user's requirements
For
entering
[/Welcome/Settings/Commissioning/User]
At the commissioning level, a shortcut exists to the principal user set up menus. These
consist of:
· Setting up the filter mode for the main settings. After selecting the desired value,
press
· Setting up the harmonic selection table for the main settings. After entering the
desired values (cf.
displayed.
· Setting up the reactive power requirements including balancing for the main
settings. After selecting the desired values, press
· After entering the data, the main settings can be copied on to the auxiliary
settings (if desired) by pressing
· The set-up ends by displaying the main commissioning menu.
Remarks:
· Refer to
settings, the filter mode, the harmonics selection table and reactive power setup
possibilities.
· A more complete user set up process can be done at he customer settings level
(cf.
Section
· In order to interrupt the set up process, press
message appears. It should be noted that any parameters entered before the
procedure is stopped, will have been recorded in the filter's memory. Re-enter
the user set up to change the values again if desired.
7.7.3
The 'Installation settings' menu [/Welcome/Settings/Installation set.]
WARNING: The installation settings menu is intended to be used by qualified
commissioning engineers that are authorized to change the filter's advanced
settings.
The filter's advanced settings include:
· the auto restart function
the
user's
requirements
to go to the next step.
Section
7.7.1.1), press
Section 7.7.1.1
for more explanation on the main and auxiliary filter
7.7.1)
Manual Power Quality Filter PQFS ç The PQF-Manager user interface 99
), the filter will reset and the new value will be
at
the
commissioning
repeatedly until the next step is
to go to the next step.
. Pressing any other key will omit this step.
repeatedly until the stop
level,
go
to
Advertisement
Table of Contents
Troubleshooting
