ABB PQFS Installation, Operation And Maintenance Instructions page 31

· Unpack the filter as per
· Transport the filter to the location of installation as per
· Mount the filter fixation bar
horizontal fixation. Holes in the supporting bar are intended for bolts M8.
Figure 22: Fixation bar and characteristic dimensions
· Carefully lift the enclosure and slide it down over the fixation bar until it is
supported by the fixation bar
disengaged.
· Once the filter is supported by the fixation bar, use the 2 screws provided with the
fixation bar to block the filter against the rear support (see
ensure that the torque used for tightening these M8 bolts is 1.4 Nm (max.) Over
tightening may result in deformation of this bar which may damage other
components inside the filter
Section 3.3
(Figure 22) on the wall. Use a spirit level to ensure
(Figure 23). Then the lifting tool can be
Figure 23: Lifting the filter
Manual Power Quality Filter PQFS ç Mechanical design and installation 31
Section 3.4
Figure 24). Please