Lan; Configuration - Siemens LOGO! CMR2040 Operating Instructions Manual

Configuration (WBM)

5.9 LAN

Deleting the configuration of the logging
To delete a loaded configuration again:
● Click the "Delete" button.
The "Activate logging and save on SD card" check box is disabled and grayed out again.
The CMR is once again in normal operation.
Activate logging
After successful transfer of the configuration file:
1. The "Activate logging and save on SD card" check box is enabled.
2. Start the logging by selecting the check box and clicking the "Apply" button.
Note
To spare the SD card: Deactivation recommended
To spare the SD card (working life), deactivate this function again after your problem has
been solved:
• Deselect the "Activate logging and save on SD card" check box.
• If you click the "Apply" button, you adopt this setting.
Deactivating logging
If you remove a loaded logging configuration, the check box is disabled and grayed out. The
CMR is once again in normal operation.
5.9 LAN
5.9.1

Configuration

Function of the LAN interface X1P1
● The X1P1 interface (Ethernet RJ-45) of the CMR is used to connect a local PC for the
configuration.
● After completed configuration, the X1P1 interface serves to connect to the BM if the CMR
is not being operated in standalone mode.
For information on the operating options, refer to the section Mobile wireless
communication by SMS / e-mail without LOGO! BM (Page 21).
You will find the properties of the X1P1 interface in the section Technical specifications
(Page 141).
By using autonegotiation and autocrossing, the transmission properties of the interface are
detected automatically and set.
84
LOGO! CMR2020,
Operating Instructions, 10/2016, C79000-G8976-C356-03
LOGO! CMR2040