Manual Station Scan; Manual Station Tuning - Silvercrest SWED 100 B1 User Manual And Service Information

SilverCrest SWED 100 B1
 Press the "TIME/MEM" button (15) for approximately 3 seconds to start
the automatic station scan. The automatic station scan always starts at
the lowest frequency. On the display, "PRESET" (33) lights up and
"SCAN" (32) flashes.
 The world receiver (A) now searches the entire frequency range for
stations with strong signals. On the display (7), the frequency indicator
stops momentarily as soon as a station with a strong signal is found and
the preset location (35) where this station is stored is displayed briefly.
 The 20 first found stations are directly saved on the presets 0 to 19.
Preset number 20 displays as "0".
The search stops after all 20 presets have been assigned. Then the station
stored in preset 1 will be tuned in.
Please note that already occupied presets are overwritten.

Manual station scan:

 Turn the device on.
 First, select the desired frequency band with the "BAND" button (11).
 Press the "UP" (6) or "DOWN" button (14) for approximately one
second to start scanning in the desired direction. The scanning stops at
the next available station and the frequency of the station is indicated
on the display (7).

Manual station tuning

As an alternative to the station scan, you can also tune in stations
manually. This enables you to find stations with weaker signals also.
Proceed as follows:
22 - English