Appearance Of The Switch Module; 1/10Gb Lan Switch Module - Hitachi Compute Blade 2500 Getting Started Manual

LAN port for connecting to the management LAN. There are two LEDs
next to the port.
¢
¢
#
2 LID LED
.
This LED identifies the management LAN module. You can turn this LED
on or off from the Web console. You can use this LED to easily identify the
location of the target management LAN module.
3 MAINT port
.
This port is used exclusively by maintenance personnel when maintaining
the system unit. Users cannot use this port.
4 PWR/WRN LED
.
The lights of this LED signify the following statuses:
¢
¢
¢

Appearance of the switch module

The switch module has connectors for connecting the system unit to external
networks and indicators to show the status of the switch module itself. This
section describes the appearance, connectors, and indicators for each switch
module supported by the CB 2500.

1/10Gb LAN switch module

The appearance of the 1/10Gb LAN switch module is shown below.
The connectors and indicators of the 1/10Gb LAN switch module are
described below.
The LED on the left lights up when a link to the network is
established.
The LED on the right flashes when the module is communicating via
the network.
The MGMT2 port cannot be used.
Green light ON: The management LAN module is running correctly.
Flashing green: A failure has occurred on the management LAN
module.
OFF: The management LAN module is powered off.
Figure 2-25 1/10Gb LAN switch module
CB 2500 Appearance
Hitachi Compute Blade 2500 Series Getting Started Guide
2-21