Connecting The G30; Connecting The G30 Adapter - Motorola G30 Technical Information

Initial Setup
.
Figure 2-2: Connecting the G30 Adapter

Connecting the G30

To Connect the G30 to the Developer Board
1. Connect the internal RF cable U.FL connector to the U.FL connector of the G30 by pushing
it until it clicks
2. Place the G30
push the G30 70-pin connector down into the G30 70-pin connector on the Developer Board.
The two screw holes on the G30 should be aligned with the G30 spacers (denoted by M2 and
M3).
3. Fasten the G30 to the Developer Board using the two M2 screws provided with the kit.
4. Insert the External Antenna Connector into the dedicated hole in the Developer Board cover
and close nut.
5. Connect the external RF cable between the External Antenna Connector and the Internal
Antenna Connector
This connects the G30 to the antenna.
10
G30 Adapter
G30 Adapter
MMCX
Screw
Connector
(Figure 2-3).
(Figure 2-4) on the Developer Board area, marked by a white rectangle, and
(Figure 2-4).
G30 Developer's Kit
Internal
Antenna
Connector
External
RF Cable
External
Internal
Antenna
RF Cable
Connector
December 15, 2009