Uid - S170; General Function Switch - S140; S170 Switches - Motorola G30 Technical Information

Configuration
The GPIO switches have two positions: Logic High (left position, marked with "H") and Logic
Low (Right position, marked with "L"). When setting a switch to "H" (default position), the
GPIO line is not connected (uses the internal G30 pull-up resistor), when setting the GPIO to "L",
the line is being shorted to ground.
Caution:

UID - S170

Note:
Figure 2-20
S170 component.
Figure 2-20: S170 Switches

General Function Switch - S140

Note:
30
In order to avoid unnecessary load on one of the GPIO lines, verify that when a
GPIO line is configured as an output and is set to logic High state, the
corresponding GPIO switch is set to "H".
The UID S170 is not applicable for G30 Adapter Board/G30.
shows the UID switches provided on the Developer Board, which are located on the
The S140 is not applicable for G30 Adapter Board/G30.
G30 Developer's Kit December 15, 2009