Antenna; Power Up; Sim Tray - Motorola G30 Technical Information

Initial Setup
A diagram on the cover indicates how to insert the SIM card.
Figure 2-7: SIM Tray
Note:

Antenna

To Attach the Antenna
•
Screw the supplied antenna into the antenna base, located at the bottom-right corner on top of
the Developer's Kit.
The Developer's Kit arrives configured to operate with its on-board internal antenna. The
EXT ANT
the board's right side

Power Up

Important:
To Turn on the Power
1. Turn on the Developer Board power by switching the power On/Off switch (S200) to ON
(Figure
The Developer Board power On/Off switch (labeled Power ) is located at the rear of the
Developer Board.
The Developer Board power indicator LED is lit.
2. Turn on the G30 power by pressing the On/Off pushbutton (S110) for at least 0.5 seconds
(Figure
The G30 power On/Off pushbutton is located at the front of the Developer Board.
14

SIM Tray

When using a G30 with an Embedded SIM, verify the following:
1. A SIM card is not inserted into the SIM tray.
2. G30 "ESIM_RST" and "SIM_RST" signals are shorted on the EVB. This could be
done by manually shorting P100 header pins 56 and 44.
and INT ANT connectors are connected together using an external RF cable, on
(Figure 2-2
You must turn the Developer Board power on before turning on the G30.
2-5).
2-8).
G30 Developer's Kit
and Figure 2-3).
December 15, 2009