On-Board Reset Button; G30 Reset Switch; Rs232-2 Connector Pinout (J330) - Motorola G30 Technical Information

This UART signals are active-low CMOS-level signals (0-2.7 V), which are converted by the
Developer Board to standard RS232 levels for PC communications. The RS232-2 Connector
Pinout (J3300) is shown in

On-board Reset Button

Note:
The S1 button is directly connected to G30 reset input pin. Pressing this button causes the module
to perform soft reset. This is valid when the module is turned ON. See
Figure 2-13: G30 Reset Switch
December 15, 2009
Table 2-5.
Table 2-5: RS232-2 Connector Pinout (J330)
Pin #
1
NA
2 RXD
3 TXD
4
NA
5 Ground
6
NA
7
RTS
8 CTS
9
NA
The On-Board Reset Button is applicable only when G30 adapter is used.
G30 Developer's Kit
Chapter 2: Developer Board and Interfaces Description
Description DTE I/O
NA
In
Out
NA
NA
Out
In
NA
Figure 2-13.
Reset
Button
21