Configuration
Configuration
After performing Initial Setup (previous section), you can continue using the Developer Board
this default setup. This section describes how to change the default setup so you can use different
peripherals or change default board operation.
Alternate Power Sources
The Developer Board power can be supplied from:
•
Wall mount power adapter
•
External DC power source
A single power source is used for the G30 and the board peripherals.
You must connect the Developer Board to a power source, and then set the power source jumper
(P204), if necessary
Two other jumpers
•
P201
•
P200
Figure 2-9: Power Supply Connectors, Jumpers and Switches
Each power supply option is described in the sections that follow.
16
(See "Wall Mount Adapter Operation" on page
(See "DC Power Source Operation" on page
(See "Selecting the Power Source" on page
(Figure
2-9) help control the power supply in the Developer Board:
—Connects/disconnects the power from the Developer Board peripherals
—Connects/disconnects the power from the G30
P201
P200
(Developer Board
(G24 Power
Power Jumper)
Jumper)
G30 Developer's Kit
19.).
DC Power
Connectors
(Not Included)
17.)
18.)
Wall Mount
Adapter
Connector
P203
(Adapter Power
Jumper)
P204
(P.S Power
Jumper)
December 15, 2009