Record Playback Options - Philips 250ML Operation Manual

250ML Lighting Control Consoles
• See "Submaster Options" on page 31
• To continue recording a Playback, as indicated in Figure 51, press (S5 - Type) twice to change the Type setting to
Playback.
• When all settings are correct, press ENTER to complete the record sub action. An alternate method is to press and
hold the submaster's bump button for 3 seconds to complete the record command.
• Once the submaster is recorded, the submaster's bump button will be lit in blue and the channel's levels will still be
active in red. Press [CLR] [CLR] to release and now the submaster shall function correctly.
• At this point the playback submaster will function as a normal submaster simply because there is only one set of
stored data. Repeat the process of setting levels and recording into the same submaster
[RECORD][BUMP][ENTER] to store the second set of levels to the same submaster.

Record Playback Options

When the playback's bump button is pressed, the following playback screen will appear as shown in Figure 52.
S2 - Color, S3 - Beamshape, and S4 - Position:
Color refers to all Color parameters, Beamshape refers to all beam related parameters and Position refers to pan / tilt
and any other position related parameters.
• Snap - color, beam and position values shall output to their stored values in a zero time when the cue is activated.
• Fade - color, beam and position values shall fade with the transition of the cue using the time of the cue.
• Snap@100% - color, beam and position values shall output to the stored values in a zero time when the cue is com-
pleted.
S6 - Insert:
This option will store the current values and add a step prior to the existing step.
S7 - Delete:
This option will delete the selected playback. Once (S7) is pressed, this operation must be aborted or confirmed. Press
(S9 - Exit) to abort or (S10 - Enter) to confirm.
WARNING! Once executed, this command cannot be reversed.
Encoder A - C - Step U/D (Current Step):
Notice that the Current Step indicator in the screen is one number higher than the total steps and there is an asterisk.
This indicates that a new step will be added. By adjusting the Current Step encoder, the Current Step will change to
one of the existing recorded steps and allow the ability to record over an existing step indicated by Current Step.
Normally this encoder would not be adjusted and the current values will be added as a new step in the submaster
playback.
• Encoder B - Speed: this will adjust the rate at which the playback's step will wait prior to triggering the next step.
• Encoder C - Fade Up: this will adjust the rate at which the playback's step will fade up.
• Encoder D - Fade Down: this will adjust the rate at which the playback's step will fade down.
to go through all options available.
Figure 52: Record Playback Options
Operation Guide
36
Recording a Playback