Philips 250ML Operation Manual page 54

250ML Lighting Control Consoles
Operation Guide
Finish by clearing out the adjusted channels as follows:
Repeat level adjustment as follows:
Store the second step to Submaster 1 as follows:
Figure 84: Record Step Chase
Since the info in Submaster 1 has already been designated as an effect, that step doesn't need to be repeated. However
Total Step will display as 01 and Current Step as 02. If you want the default of the current step adding to the end of
the step list, then no adjustment is needed. However if you need the step that you are recording to be in front of the
currently recorded step 1, then adjust the C-Step U/D option on Encoder A. Also, this is a good time to adjust the
Speed of the effect. For this example, please leave the Current Step set to 02.
Finish by clearing out the adjusted channels as follows:
Repeat level adjustment as follows:
Store the third step to Submaster 1 as follows:
Just move the submaster's fader to full to see the effect run.
5 3
OPERATION