Changing Operands, Set Values - Mitsubishi Electric GOT2000 Series User Manual

16.2.11 Changing operands, set values

Changes the operand section of an applied instruction and OUT (T, C) command set value.
■1. Operation
Stop the FX PLC
*1
■2. Example
Changing "MOV D0 D10" to "MOV D0 D123"
Stop the FX PLC
MODE
Move the cursor to the changed
location with
16 - 30
16.2 FX List Editor (GT2105-Q, GT2104-R only)
MODE SP
(Read mode)
For decimal numbers, input K, then the number.
For hexadecimal numbers, input H, then the number.
POINT POINT POINT
Moving the cursor to the line on which the operand or set value is to be changed
When starting to change an operand or a set value, place the cursor on the line of the operand or
set value to be changed (the line on which the step number is not displayed).
If you place the cursor on the command line, the input operation is not possible.
< READ >
Set the
WRITE
< WRITE >
mode.
or
Input the device name and device number
3 MOV
D
D
8 LD M
SP D
3 MOV
D
D 123
8 LD M
GO
12
0
10
10
1 2 3 GO
12
0
10