Changing Operands, Set Values - Mitsubishi Electric GT11 User Manual

14.4.10 Changing operands, set values

Changes the operand section of an applied instruction and OUT (T, C) command set value.
Operation
1
Stop the FX PLC
*1 For decimal numbers, input K, then the number.
For hexadecimal numbers, input H, then the number.
Example
2
Changing "MOV D0 D10" to "MOV D0 D123".
Stop the FX PLC
Move the cursor to the changed
location with
14 - 100
14.4 MELSEC-FX List Editor
14.4.10 Changing operands, set values
MODE SP
(Read mode)
Moving the cursor to the line on which the operand or set value is to be changed
When starting to change an operand or a set value, place the cursor on the line of
the operand or set value to be changed (the line on which the step number is not
displayed).
If you place the cursor on the command line, the input operation is not possible.
2 LDI M 100
3 MOV
D
D
< READ >
MODE
< WRITE >
or
Input the device name and device number
Command line (Cannot
operate on this line.)
12
0
Operand, set value line
10
(Place the cursor on this line.)
3 MOV
8 LD
Set the
WRITE
3 MOV
mode.
8 LD
12
D 0
D 10
M 10
SP D 1 2 3
12
D 0
D 123
M 10
GO
GO