Installation Method Using The Program/Data Control Function (Utility) - Mitsubishi Electric GT11 User Manual

16.3.2 Installation method using the program/data control function (Utility)

For details of program/data control function, refer to the following.
Program/data control is a function to install OS files from the CF card to GOT by the Utility operation.
Operation procedure
1
16 - 6
16.3 BootOS and Standard Monitor OS Installation Using CF Card
16.3.2 Installation method using the program/data control function (Utility)
Chapter 13 FILE DISPLAY AND COPY (PROGRAM/DATA CONTROL)
Precautions on executing program/data control function
When execute program/data control function, Standard monitor OS has to be
installed in GOT in advance. Thus, this function cannot be used for the initial
installation of Standard monitor OS after purchasing GOT.
Install Standard monitor OS by the following two methods.
(1) Method using drawing software
GT Designer2 Version
GT Designer3 Version1 Screen Design Manual (Fundamentals)
(2) Installation method when turning the GOT power on
Section 16.3.1 Installation method when the GOT is turned on
Touch [Install].
Basic Operation/Data Transfer Manual
Power OFF the GOT. After CF card access
1
LED is off, install the CF card in which
BootOS, Standard monitor OS or project
data is stored in the CF card interface of
GOT.
Switch ON the CF card access switch of
2
GOT.
Display the program/data control function
3
screen (Utility) on the GOT, and install
BootOS, Standard monitor OS from the CF
card to GOT.