ABB ACS550-01 User Manual page 54

54
Step Action
5. • To accept the new value and continue to the setting of the next parameter,
SAVE
press .
• To stop the assistant, press
The table below lists the tasks of the assistants and the relevant drive parameters.
Depending on the selection made in the Application task (parameter
MACRO), the Start-up Assistant decides, which consequent tasks it suggests.
Name Description
Language select Selecting the language
Motor set-up Setting the motor data
Performing the motor identification. (If the speed limits are not in
the allowed range: Setting the limits.)
Application Selecting the application macro
Option modules Activating the option modules
Speed control Selecting the source for the speed reference
EXT1
(If AI1 is used: Setting analog input AI1 limits, scale, inversion)
Setting the reference limits
Setting the speed (frequency) limits
Setting the acceleration and deceleration times
Speed control Selecting the source for the speed reference
EXT2
(If AI1 is used: Setting analog input AI1 limits, scale, inversion)
Setting the reference limits
Torque control Selecting the source for the torque reference
(If AI1 is used: Setting analog input AI1 limits, scale, inversion)
Setting the reference limits
Setting the torque ramp up and ramp down times
PID control Selecting the source for the process reference
(If AI1 is used: Setting analog input AI1 limits, scale, inversion)
Setting the reference limits
Setting the speed (reference) limits
Setting the source and limits for the process actual value
Start/Stop control Selecting the source for start and stop signals of the two external
control locations, EXT1 and EXT2
Selecting between EXT1 and EXT2
Defining the direction control
Defining the start and stop modes
Selecting the use of Run Enable signal
Timed functions Setting the timed functions
Selecting the timed start/stop control for external control locations
EXT1 and EXT2
Selecting timed EXT1/EXT2 control
Activation of timed constant speed 1
Control panels
EXIT
.
ACS550-01/U1 User's Manual
Display
LOC PAR EDIT
9906 MOTOR NOM CURR
1.2 A
EXIT 00:00
9902 APPLIC
Set parameters
9901
9904...9909
9910
9902, parameters associated to
the macro
Group 35: MOTOR TEMP MEAS
Group 52: PANEL COMM
9802
1103
(1301...1303, 3001)
1104, 1105
2001, 2002, (2007, 2008)
2202, 2203
1106
(1301...1303, 3001)
1107, 1108
1106
(1301...1303, 3001)
1107, 1108
2401, 2402
1106
(1301...1303, 3001)
1107, 1108
2001, 2002, (2007, 2008)
4016, 4018, 4019
1001, 1002
1102
1003
2101...2103
1601
Group 36: TIMED FUNCTIONS
1001, 1002
1102
1201
SAVE