Installation; Installation Flow Chart; Preparing For Installation - ABB ACS550-01 User Manual

ACS550-01/U1 User's Manual

Installation

Study these installation instructions carefully before proceeding. Failure to observe
the warnings and instructions may cause a malfunction or personal hazard.
WARNING! Before you begin read chapter
Note: The installation must always be designed and made according to applicable
local laws and regulations. ABB does not assume any liability whatsoever for any
installation which breaches the local laws and/or other regulations. Furthermore, if
the recommendations given by ABB are not followed, the drive may experience
problems that the warranty does not cover.

Installation flow chart

The installation of the ACS550 adjustable speed AC drive follows the outline below.
The steps must be carried out in the order shown. At the right of each step are
references to the detailed information needed for the correct installation of the drive.
PREPARE for installation
PREPARE the mounting location
REMOVE the front cover
MOUNT the drive
INSTALL wiring
CHECK installation
REINSTALL the cover
START-UP
Task
Safety on page 5.

Preparing for installation

on page
Prepare the mounting location
Remove the front cover on page
Mount the drive on page
Wiring overview on page
Install the wiring on page
Check installation on page
Reinstall the cover on page
How to start up the drive
See
12
on page 16
17
18
19 and
26
31
32
on page 33
Installation
11