Installing The Drive - ABB ACS550-01 User Manual

16

Installing the drive

WARNING! Before installing the ACS550, ensure the input power supply to the drive
is off.
For flange mounting (mounting the drive in a cooling air duct), see the appropriate
Flange Mounting Instructions:
Frame size
R1
R2
R3
R4
R5
R6
1. Not available in ACS550-01 series.
Prepare the mounting location
The ACS550 should only be mounted where all of the
requirements defined in section
on page
1. Mark the position of the mounting holes with the help of
the mounting template provided with the drive.
2. Drill the holes.
Note: Frame sizes R3 and R4 have four holes along the top. Use only two. If
possible, use the two outside holes (to allow room to remove the fan for
maintenance).
Note: ACS400 drives can be replaced using the original mounting holes. For R1 and
R2 frame sizes, the mounting holes are identical. For R3 and R4 frame sizes, the
inside mounting holes on the top of ACS550 drives match ACS400 mounts.
Installation
IP21 / UL type 1
Kit
FMK-A-R1
FMK-A-R2
FMK-A-R3
FMK-A-R4
1
AC8-FLNGMT-R5
1
AC8-FLNGMT-R6
12 are met.
Code (English)
100000982 FMK-B-R1
100000984 FMK-B-R2
100000986 FMK-B-R3
100000988 FMK-B-R4
ACS800-PNTG01U- -
EN
-
Preparing for installation
ACS550-01/U1 User's Manual
IP54 / UL type 12
Kit Code (English)
100000990
100000992
100000994
100000996
-
-
1
X0002