Mitsubishi Electric GOT2000 Series User Manual page 106

(2) Ethernet I/F assignment
Several drivers are assigned to the same Ethernet interface. However, only one GOT IP address is assigned per
interface.
By changing the settings of one interface, the GOT IP address, GOT port No. download, default gateway and subnet
mask settings of other drivers, which are assigned to the same interface, are also changed.
Step 1.
Touch the [Assign Ethernet I/F] button in [Communication setting].
Step 2.
Touch the driver display BOX of the communication parameter to be set in the [Ethernet I/F assignment]
screen.
Step 3.
The screen switches to the detail setting screen.
Set communication parameters from this screen.
Refer to the following for the setting change operation.
➠
2 - 62
2.10 Controller
POINT POINT POINT
(1) Communication parameter setting by GT Designer3
Set the communication parameters for each communication driver at [Communication
Settings] in [Controller Setting] of GT Designer3.
When change the communication parameters after downloading project data, change the
setting at communication detail setting of GOT.
➠ GOT2000 Series Connection Manual for the controller used
GT Designer3 (GOT2000) Screen Design Manual
(2) For the Ethernet multiple connection
Touch the driver display BOX of the Ethernet connection, and then the communication detail
setting screen of Channel No. 1 is displayed.
1.3.3 Basic operation of settings change