Installing the AY-RP500 board
(JOG board)
1. Remove the cover from the ISA slot (the black connector
on the motherboard) that is the farthest away from the
CPU.
2. Carefully remove the AY-RP500 board (the JOG board)
from its anti-static protective pack. If you need to set the
board down, place it on top of this pack.
3. Use the jumper pins to set the IRQ and the I/O port.
The permitted settings for the IRQ are 3, 4, 5, and 7; the
permitted settings for the I/O port are 230H, 240H, 330H,
and 340H.
For IRQ, insert the jumper pin into jumper P9 and set.
(See item2, page 1.)
• To set "3" as the IRQ:
p Push in the jumper pin here.
IRQ3
•
•
IRQ4
•
•
IRQ5
•
•
IRQ7
•
•
• To set "4" as the IRQ:
IRQ3
•
•
p Push in the jumper pin here.
IRQ4
•
•
IRQ5
•
•
IRQ7
•
•
• To set "5" as the IRQ:
IRQ3
•
•
IRQ4
•
•
p Push in the jumper pin here.
IRQ5
•
•
IRQ7
•
•
• To set "7" as the IRQ:
IRQ3
•
•
IRQ4
•
•
IRQ5
•
•
p Push in the jumper pin here.
IRQ7
•
•
For I/O port, insert the jumper pin into jumper P12 and set.
(See item3, page 1.)
• To set "230H" as the I/O address
(Factory setting):
P 1
•
•
P 2
•
•
P 3
•
•
• To set "240H" as the I/O address:
P 1
•
•
P 2
•
•
P 3
•
•
• To set "330H" as the I/O address:
P 1
•
•
P 2
•
•
P 3
•
•
• To set "340H" as the I/O address:
P 1
•
•
P 2
•
•
P 3
•
•
Since the JOG board uses IRQ and I/O port exclusively,
be certain to set a number that are not used by any other
device.
Confirm settings of other devices using the WindowsNT
diagnostic program (page 6).
Note on IRQ Settings:
"5" and "7" are recommended.
If "5" and "7" are being used by another device, set
either "3" or "4". Because "3" and "4" are normally used
for serial ports (COM1, COM2), either "3" or "4" must be
disabled in the BIOS settings. (Set to "Disable" etc.) In
this case, only one serial port can be used.
For details on how to set the BIOS, refer to the
instruction manual that was provided with your
computer.
9
Do not push in jumper pins.
p Push in the jumper pin here.
p Push in the jumper pin here.
p Push in the jumper pin here.
p Push in the jumper pin here.