Advertisement
3. Insert the hard disk, and attach it with screws (in four
places).
The assembly diagram shown below is intended as an
example. The actual connection locations may differ
depending on the mode computer used.
When installing another hard disk unit, remove the
expansion bay brackets, insert the hard disk, and then
secure it in place with screws, then secure it in place with
screws (in for places). (Refer to the diagram below.)
The assembly diagram shown below is intended as an
example. The actual connection locations may differ
depending on the mode computer used.
Insert into lower bay
4. Use the flat cable (68-08n, Wide-SCSI) provided with the
SCSI board. Connect one end to the connector on the
hard disk, and connect the other end to the connector on
the SCSI board. (Refer to the diagram below.)
The assembly diagram shown below is intended as an
example. The actual connection locations may differ
depending on the mode computer used.
• When there is only hard disk, connect to the A channel
connector on the SCSI board.
• When there are two hard disks, connect one to the A
channel connector on the SCSI board, and one to the B
channel connector. Be sure to connect the power supply
connector.
Hard disk
SCSI board
Channel A
13
Screws
Channel B
Advertisement
