6 ] Margin Adjustment In Near-Edge Printing - Brother MFC640CW Service Manual

[ 6 ] Margin adjustment in near-edge printing

(1) On the PC, run "FILEDG32.exe" in the folder created in
The Filedrgs window appears as shown below.
(2) Drag and drop the "EDGE_CHECK.PRN" onto the BHL2-Maintenance Printer icon in the
Filedrgs window shown above.
The machine displays the "RECEIVING DATA" on the LCD and prints out the margin check
pattern (see
(3) Measure the left and right margins on the printout.
(Example) Left: 1.0 mm, Right: 1.3 mm
If both margins are within the range from 0.9 to 1.1 mm, no adjustment is required.
(4) MFC820CW/640CW
If either margin is out of the specified range, press the 6 key twice on the machine.
DCP340CW
If either margin is out of the specified range, enter 6 twice by using the
machine.*
(*To enter a numerical code on models having no numerical keypad, press the
display the numerical code to be entered and then press the Set key. Repeat this operation for each
numerical code.)
The "MEDIA SENSOR ADJ" appears again.
(5) MFC820CW/640CW
To make the machine ready for data entry, press the * key.
DCP340CW
To make the machine ready for data entry, enter * by using the
page 6-19 for a sample printout).
Section 6.1.1.
6 - 1 7
and Set keys on the
key several times to
and Set keys.*
Confidential