Installing The Sim Cards - Siemens RUGGEDCOM RX1400 Installation Manual

RUGGEDCOM RX1400
Installation Guide
Figure 8: Antenna and Lightning Protector Assembly (Optional)
1. Drain Wire 2. RUGGEDCOM RX1400 3. Shielded Coaxial Cable 4. Lightning Protector 5. Ground Wire 6. WLAN Antenna
Section 2.7

Installing the SIM Cards

The RUGGEDCOM RX1400 supports dual micro-SIM cards for the LTE modem to provide a fail-over mechanism
should one of the SIM cards lose connectivity with the network.
To install micro-SIM cards from a regional cellular carrier, do the following:
CAUTION!
Static electricity hazard – risk of damage to equipment. Take appropriate anti-static precautions before
accessing the SIM cards.
1. Remove the SIM card access panel.
Figure 9: Accessing the SIM Cards
1. Access Panel 2. Secondary Micro-SIM Card 3. Primary Micro-SIM Card
2. Insert the SIM cards into the slots. Slot 1 is for the primary SIM card and slot 2 is for the secondary (backup)
SIM card.
3. Close the access panel and secure it with the two screws.
Installing the SIM Cards
2 3
1
1
4 3 5 5
1
3
2
Chapter 2
Installing the Device
6
19