Connecting The Antennas; Technical Specifications - Siemens RUGGEDCOM RX1400 Installation Manual

Chapter 2
Installing the Device
Figure 5: Panel Mounting
1. Screw 2. Panel Adapter
2. Install the supplied screws to secure the adapters to the panel.
Section 2.6

Connecting the Antennas

The RUGGEDCOM RX1400 can be connected to external antennas for access to wireless networks. For increased
signal coverage and improved performance, antennas are intended to be installed in a remote location separate
from the RUGGEDCOM RX1400.
IMPORTANT!
The antenna installation must be as per Article 810 of the National Electric Code (NEC). Specifically, the
grounding conductor must not be less than 10 AWG (Cu). The scheme should be either:
• In accordance with UL 96 and 96A Lightning Protection Components and Installation Requirements
for Lightning Protection Systems (LPS)
• Tested in accordance with UL 50 and UL 497
NOTE
For technical specifications, refer to
CONTENTS
• Section 2.6.1, "Available Antennas"
• Section 2.6.2, "Connecting LTE Antennas"
• Section 2.6.3, "Connecting a GPS Antenna"
• Section 2.6.4, "Connecting WLAN Antennas"
12
1
2
Section 4.5, "Cellular Modem
Installation Guide
1
2
Specifications".
Connecting the Antennas
RUGGEDCOM RX1400